Beta 1697 Gebrauchsanweisung Seite 5

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
LASER LEVEL
OPERATION MANUAL AND INSTRUCTIONS FOR LASER LEVEL MANUFACTURED BY:
BETA UTENSILI S.P.A.
VIA A. VOLTA 18,
20845, SOVICO (MB) ITALY
ORIGINAL DOCUMENTATION DRAWN UP IN ITALIAN.
CAUTION
Store the safety instructions with care and hand them over to the users.
PURPOSE OF USE
The laser level can be used for the following purpose:
• Accurately measuring the inclination of a surface relative to a horizontal or vertical plane by means of a cross
light beam.
The laser level must not be used for the following operations:
• pointing the laser beam at any person's or animal's eyes
• use in damp or wet environments; exposure to rain or snow
WORK AREA SAFETY
Keep children and bystanders away from your workplace while operating the laser level.
Be careful not to direct the laser beam into your eyes.
LASER LEVEL SAFETY
• Before use, check that the laser level has not been damaged.
• Do not force the laser level. Do not modify any parts, as the safety measures may be affected.
• Have the laser level repaired only through a trained repair person and only using original replacement parts.
• To clean the laser level, use a dry cloth. Do not use any solvents or aggressive detergents.
• When not in use, store the laser level out of the reach of children.
• The laser level may not be used by people who have not read these instructions.
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING LASER LEVEL
Additional personal protective equipment to wear according to the values found in the environmental
hygiene/risk analysis survey if the values exceed the limits under current regulations.
TECHNICAL DATA
Accuracy
Maximum inclination that can be compensated for
Overall battery life
Working range
Laser type
Working temperature
Batteries
Protection degree
Support mount
IMPORTANT! READ THIS MANUAL THOROUGHLY BEFORE USING
THE LASER. FAILURE TO COMPLY WITH THE SAFETY STANDARDS
AND OPERATING PROCEDURES MAY RESULT IN SERIOUS INJURY.
±1 mm x 5m
4±0.5°
≥4 h
15m
515nm, laser class II
Da -10°C a +50°C
2 x 1,5V AA
IP 55
1/4"
EN I
5