EUROMACH R 755 Technisches Handbuch Seite 10

The board panel is equipped with an inboard computer that allows to control all the data of the
machine and of the engine.
The cabin is equipped with heating system and air conditioner inside the cab (option), no
projection over the cabin.
Controls
The working functions are controlled through 2 joysticks, located on the two sides of the seat,
and 3 foot pedals.
All boom functions (including bucket and additional accessories), rotation and traction can be
feathered. The under carriage functions are controlled with an on/off control valve.
The working functions are activated when the micro switch located on the left armrest is
activated, the system is activated when the armrest is lowered in working position.
The steering function is activated with a the buttons on the joysticks.
Various
The most stressed parts of the excavator are made out of high strength steel. (minimum
warranted yielding load equal to 700 – 900 N/mm2).
Buckets and legs are made out of special steel that has a high resistance against wearing.
The pins are made out of case-hardened 16CrNi4 steel. Maximum resistance against wearing.
The cylinders piston roads are made out off induction hardened and tempered 42CrMo4 steel
successively chromed. The procedure warrants a good strength of the cylinders and a surface
resistance against chocks.
Accessories
List of the accessories and options that can be installed on the excavator:
•
The excavator can be supplied with buckets of various dimensions, all of them made out
off high resistance steel, a list follows:
Excavating bucket
o
Rock bucket
o
Channels cleaning bucket
o
Revolving channels cleaning bucket
o
•
The excavator can be equipped with a hydraulic activation for additional equipments
that can be installed on the boom tip. (The equipment can be supplied directly by
EUROMACH)
Bush-cutter machine
o
Power tilt
o
Grab
o
Demolition cutter
o
Deforestation equipment
o
Hydraulic demolition hammer
o
...
o
•
Automatic greasing system (upper part and under carriage)
•
Air conditioning inside the operator's cab
•
Safety greed for second level FOPS (following ISO 3449 standards)
•
Steel amphibian plates to be used in slumps
•
Flat foot with plastic to be used on asphalt
•
Hydraulic winch (minimum capacity 3000 Kg), the winch can be installed on both the
front or the rear sides of the excavator, the wire rope drums guide is installed on the
rear side of the excavator. The winch includes the wire rope pressing roller and anti
unrolling system (it prevents the unrolling of the wire rope and stops the winch when
Edizione 01/20 – Revisione 00
Technical Specifications – R755
R755
Gen. 20
UT
T
10