Asus V6-Serie Installationshandbuch Seite 7

Installing an expansion card
1. Remove the metal cover opposite the
slot that you intend to use.
3. Insert the card connector to the slot��
then press the card firmly until it fits in
place.
4. Replace the metal bracket lock.
Installing storage drives
Optical drive
1. Place the chassis upri�ht�� then remove the upper 5.25" drive bay metal plate cover.
2. Insert the optical drive to the bay�� then carefully push the drive until its screw holes
ali�n with the holes on the bay.
3. Secure the optical drive with two screws on both sides of the bay.
4. Connect the I�� (4A) and power (4B) plu�s to connectors at the back of the drive.
3
Floppy disk drive
If the system comes without a portable hard disk (optional), then you may install a floppy disk
drive into the 3.5-inch drive bay.
1. Place the chassis upri�ht�� then remove the upper 3.5" drive bay metal plate cover.
2. Insert the floppy disk drive to the bay, then carefully push the drive until its screw holes
ali�n with the holes on the bay.
3. Secure the floppy disk drive with two screws on both sides of the bay.
4. Connect the si�nal (4A) and power (4B) plu�s to connectors at the back of the drive.
3
V7-P5G43 QSG.indb 7
1
2
3
3
2
Installation manual
2. Remove the metal bracket lock.
2
4
4A
4A
3
4B
4B

��1�0� 4:5�:55 PM