Caliber TWS 100A Bedienungsanleitung Seite 7

Pairing (Fig. 11)
If keep the lid open but there is no Bluetooth connection is made for 5 minutes,
the earbuds will turn off automatically.
11
Couple Earbuds Mode
1. Uncover the lid and the earbuds will turn on automatically. They will connect
with each other. Once connected, The LED indicator on Right earbud will flash
blue and red or white and red alternatively. The LED indicator on Left earbud
will flash blue or white intermittently indicating the earbuds are in pairing mode
now.
2. Turn on the Bluetooth function on your device and search for nearby
devices. Find "TWS100A" in the searching results, tap on the name to
connect.
3. Once connected, the LED indicators on both earbuds will be turned blue or
white intermittently.
4. Take out both earbuds from the charging case. The LED indicators on both
earbuds will be turned off.
07
L R
Note:
• If the earbuds failed to pair with each other, please disconnect the Bluetooth
connection with your device, put them back into the charging case, close the lid
then open it and take out the earbuds to pair again.
• It is not recommended to wear the two earbuds on different people. If needed,
please keep the 2 earbuds within 3 meters / 9.8 feet in couple earbuds mode.
Single Earbud Mode
1. Repeat the steps correspond to Couple Earbuds Mode. Take out one earbud
from the charging case, and make sure the other one is placed in the charging
case.
Note:
If you want to change to couple mode, simply take out the other earbud from the
charging case, they will pair with each other automatically.
If you want to swap to another earbud, simply take out the other earbud from the
charging case and put the earbud just being used back to charging case.
Note:
If you want to pair the earbuds with another device when you have already paired
them with a device, deactivate the Bluetooth function on the paired device or
clear "TWS100A" from its Bluetooth list.
08