Keyboard Customization - KLIM SHIFT Benutzerhandbuch

ENGLISH

KEYBOARD CUSTOMIZATION

Replacing the keycaps
This keyboard includes a set of spare white
keycaps that you can install to give your
keyboard a unique look. Use the keycap
removal tool to extract the keycaps by pressing
down until the keycap is hooked, then pulling up. Take the
replacement keycap and install it by aligning it with the switch
and firmly pressing down.
Tip: make sure you place them in the right position! Otherwise it
can be confusing to use the keyboard (unless you're a touch-
typing master, that is).
Here are some layout ideas:
Frame/frameless mode
The frame of the keyboard is removable. Grab the keyboard and
push down with your thumbs while pulling the frame upwards.
To reinstall it, simply place it in position again until it is
magnetically attached.
Replacing the switches (advanced users only!)
This keyboard is hotswappable, which means you can swap the
switches without any soldering. Here are the instructions on
how to go about it:
1. Use the key removal tool to extract the keycaps (as explained
in the previous section).
2. Clamp the front and back of the switch (NOT the left and
right) using a switch puller and pull up until you completely
remove the switch.
3. Take the new switch and push it down with your hand until it
is set in place. Pay attention to the switch orientation and
make sure the pins are properly aligned!
4. Reinstall the keycap by hand and enjoy your new switches!
6