Quick Setup - Aqara P1 Bedienungsanleitung

Quick Setup

1. Before activating the accessory, please make sure you
have the Aqara Home app downloaded and an Aqara
Zigbee 3.0 hub installed.
2. Remove the insulating pull tab.
Pull the tab out from under the battery contact to the
direction of the arrow to activate the product.
3. Please open the app, tap "Home" and then tap "+" in the
top right corner to enter the "Add Device (Accessory)"
page. Select "Motion Sensor P1" and add it according to
instructions in the Aqara Home app.
4. Please see www.aqara.com/support for additional information.
If adding fails, please move the product closer to the hub
*
and try again.
Installation and Usage
Please confirm that communication between the motion
sensor and the Aqara Zigbee 3.0 Hub works normally, and
then install and fix it in position.
02