ecofort BlackLight Deluxe Gebrauch Und Wartung Seite 11

2. Fix the two supports (fig. 2 - pos. A) to the wall using dowels of
appropriate size.
3. Mount the two brackets (fig. 2 - pos. B) on the back of the appli-
ance, inserting and sliding them into the the longitudinal slots.
4. Join together the parts previously set, adjusting at the same
time the inclination of the appliance positioning on both sides the
screws shown in Figure 2 - pos. C.
Mo-El supplies on demand three optional brackets, shown in figure 3:
Twin (cod. 7704)
•
End to end (cod. 7705)
•
Extension (cod. 7706)
•
4. USE
The Blacklight range includes appliances with wattages ranging be-
tween 1500 W and 3200 W, suitable for heating private homes as
well as public premises (restaurants, pubs).
The appliances can be used indoors and outdoors (patios, verandas,
balconies).
The heating element of this product is hygroscopic. To avoid risk of
failures it is necessary to operate the unit for a few hours every 6
months.
This heating appliance does not feature a device to control am-
bient temperature. Do not use it in small rooms used by peo-
ple who are unable to leave such rooms on their own unless
they are under constant surveillance.
All users should be made aware of all aspects of operation and safety
and these instructions should be retained for reference.
Make certain that the rays of the heater are aimed at the area to heat.
If necessary, change the angle of inclination by acting on the lateral
screws (fig. 2 - pos. C).
Do not use the heater directly near a bathtub, a shower, a swimming
pool. In unoccupied premises it is recommended that the heating
system is switched off and isolated from the electrical supply.
11