Switch Off The Cool Box; Defrost The Cooling Device; Cleaning And Maintenance; Replacing The Dc Plug Fuse - Outwell DEEP CHILL 29 Bedienungsanleitung

UK: INSTRUCTION MANUAL

7.2 Switch off the cool box

• Empty the cool box.
• Switch off the cool box.
• Pull out the cable from the socket.
If you do not want to use the cool box for a longer period of time.
• Leave the device cover slightly open as this will prevent odour build-up.

7.3 Defrost the cooling device

Humidity can form frost in the interior of the cooling device or on the vaporiser, and this will
reduce the cooling capacity of the device. Defrost the cooling device in good time to avoid this.
NOTICE! Danger of damage!
Never use mechanical, hard or pointed tools to remove ice or to loosen objects which have frozen in the
cool box.
Process the following steps to defrost the cool box
• Take out the contents of the cool box.
• If necessary, place them in another cooling device to keep them cool.
• Switch off the device.
• Leave the cover open.
• Wipe off the defrosted water.

8. Cleaning and Maintenance

8.1 Replacing the DC plug fuse

• Pull off the adaptor sleeve from the DC plug.
• Unscrew the screw in the upper half of the housing.
• Carefully raise the upper half of the housing from the lower half.
• Take out the contact pin.
• Replace the detective fuse with a new fuse with the same type and rating
• Re-assemble the plug in the reverse order.

8.2 Cleaning the cooling device

• Occasionally clean the device interior and exterior with a damp cloth.
• Make sure that the air inlet and outlet vents in the device are free of any dust and dirt,
so that heat can be released and the device is not damaged.
WARNING!
Always disconnect the device from the power supply before you clean and service it.
NOTICE! Risk of damage
• Never clean the cool box under running water or in dish water.
• Do not use abrasive cleaning agents or hard objects during cleaning as these can damage the
cool box.
8
UK: INSTRUCTION MANUAL

9. Troubleshooting

Fault Possible cause
Device does not function, No voltage was detected in
LED light does not glow. the power supply.
The cool box plug fuse is
defective.
The device does not cool Defective compressor.
(plug is inserted , "ON" LED is lit).
The device does not cool Low voltage protection battery
(plug is inserted, display screen monitor is set too high.
shows Error Code"E1").
Please also refer to chapter "5.6 Battery voltage is too low.
The explanation for the running
code shown in the display
screen".
When operating the device from The DC outlet is dirty resulting
DC outlet. (the ignition is on, in a poor electric contact.
but the device is not working,
the LED light is not on either).
The fuse of the DC plug has
blown.
The vehicle fuse has blown.
The display screen shows the Please refer to "5.6 The
Error Code and the vehicle does explanation for the running
not cool. code shown in the display
Please refer to "5.6 The screen".
explanation for the running
code shown in the display
screen".
Suggested remedy
In most vehicles the ignition
must be turned on before
power supplied to the DC
power outlet.
Replace the device plug fuse
with a new one.
This can only be repaired by an
authorized repair centre.
Select a lower level for the
battery monitor.
Test the battery and charge it if
needed.
If the plug of your device
becomes very warm in the DC
outlet, either the DC outlet must
be cleaned or the plug has not
been assembled correctly.
Replace the fuse in the DC plug,
please refer to the chapter "8.1
Replacing the DC plug fuse. "
Replace the vehicle's DC outlet
fuse, please refer to your
vehicle's manual.
This should only be repaired by
an authorized repair centre.
9