Werbung
ENG - Installation:
- The installation and connection should be carried out by a qualified
electrician.
- The electric element must not:
- You may not climb on the towel heater.
ENG - Mounting:
Follow the instructions on the last page.
Decide where the towel drier is to be installed. Make sure the wall will support
the rack and hanging wet
towels. Brick or concrete walls are ideal. If the drier is to be mounted on
plasterboard, it must be secured
with wooden joists.
PLEASE NOTE - The measurements shown are approximate. The fitter must
check the final positions of
where holes are to be drilled with the product itself and not rely solely on these
dimensions.
ENG - Advise for caring:
- The unit must be switched of while cleaning it.
- The easiest way to remove dirt, lime scale and other deposits is with soap and
water. Rinse clean and polish with a cloth or terry toweling. Avoid scouring
powder or cleansers that contain abrasives, acid or ammonia.
- Be fitted or used outside.
- Be fitted so it can fall into a bathtub or
any other water.
- Be fitted so you have access to the
electric control while showering or taking
a bath.
Dok. AS/1/2019
4
Werbung
