Battery Information - SACKit Go 300 Gebrauchsanleitung

How to use DAB+
Make sure that the radio antenna is extended before entering DAB+ mode .
1 . To enter DAB+ mode, press the Mode/Menu button (C) until "DAB" is displayed.
2 . SACKit Go 300 automatically connects to the strongest DAB+ channel.
3 . Press the left arrow (<) or the right arrow (>) to toggle between the radio channels.
4 . Pressing the Power button (B) while in DAB+ mode, will mute/unmute SACKit Go 300.
If the SACKit Go 300 is in DAB+ mode, the settings menu will offer more options. You navigate the
menu like this:
1 . Press and hold the Mode/Menu button (C) to open settings.
2 . Press the left arrow (<) or the right arrow (>) to toggle between the menu's four options (Full scan,
Manual tune, Prune and System) .
3 . Use the Power button (B) to confirm.
4 . To go back or exit the menu, press the Mode/Menu button (C).
• Full scan: SACKit Go 300 will scan all the channels in alphabetical order.
• Manual tune: Press the left arrow (<) or the right arrow (>) to toggle between all channels between
5A - 13F. Then press the Power button (B) to confirm.
• Prune: Deletes any invalid DAB+ channels.
• System: When entered, four more options appear (Time, Backlight, Factory Reset, SW Version).
How to change settings on SACKit Go 300
1 . Press and hold the Mode/Menu button (C) to open the settings.
2 . Use the Arrow buttons (<) or (>) to navigate to System.
3 . Use the Power button (B) to confirm.
4 . To go back or exit the menu, press the Mode/menu button (C).
There are four options to choose from under System:
• Time: The time and date displayed by SACKit Go 300 will set itself through the DAB+ signal. How-
ever under this setting it is possible to turn this feature off and set it manually instead.
• Backlight: Here you can choose the brightness of the display and even set a timeout on it for when
it is idle .
• Factory Reset: This option lets you reset the device to its factory settings.
• SW Version: Will display the current software version installed on the SACKit Go 300.

Battery information

• Battery: rechargeable Polymer Lithium-Ion Battery, 2200mAh.
• Power: 5V DC 0 .5-3A via USB-C .
• Charging Time: Please be sure the battery has been fully charged before first use. It can take up to
3 hours of charging the first time, but 2 hours normally with a 5V 3A adapter.
• When the device is on, the display on top of the SACKit Go 300 will show the battery status.
7