The Device; Getting Started - SACKit Go 300 Gebrauchsanleitung

THE DEVICE

Getting started

Follow these three simple steps to get started:
1 . Charge SACKit Go 300 in the USB-C port (D) with the included USB-C charger cable .
2 . Turn on SACKit Go 300 by holding down the Power button (B).
3 . Select the mode you want by pressing the Mode/Menu button (C).
It may be necessary to unfold the antenna on the back to get sufficient signal when listening to
Note:
the radio .
How to use Bluetooth
1 . To enter Bluetooth mode, press the Mode/Menu button (C) until "BT" is displayed. The screen will
then display "Connecting" and a voice will say "Bluetooth mode". SACKit Go 300 is now waiting for
connection.
2 . Switch on Bluetooth on your device
3 . Choose "SACKit Go 300" under Bluetooth settings on your device. Your speaker is now connected
to your device .
4 . Start playing music on your SACKit Go 300!
5 . SACKit Go 300 will automatically pair with the last connected device
To connect to a new device make sure that the previous connected device is disconnected otherwise
connecting opportunities won't appear on the new device.
Disconnect Bluetooth
You have to be in Bluetooth mode to disconnect.
1 . To disconnect the Bluetooth connection to a device, press and hold the left arrow (<) or the right
arrow (>) until hearing "Disconnected".
2 . SACKit Go 300 is disconnected and is now ready to pair to a new device .
How to use FM-radio
Make sure that the radio antenna is extended before entering FM mode .
1 . To enter FM mode, press the Mode/Menu button (C) until "FM" is displayed.
2 . Press and hold the left arrow (<) or right arrow (>) to scan for channels. The scan stops automatically
when the next station is found.
3 . Alternatively, press the left arrow (<) or right arrow (>) to tune up or down between the channels at
0 .05 MHz per tap .
4 . Pressing the Power button (B) while in FM mode, will mute/unmute SACKit Go 300.
6