SW-Stahl 32275L Bedienungsanleitung Seite 22

P R I N T I N G T H E T E S T R E P O R T / O T H E R E N T R I E S :
• Use ▲▼ to select the relevant value and then confirm with ENTER.
Here you have the option to note the vehicle's chassis number on the print-out.
• Use ▲▼ to select the relevant value and then confirm with ENTER.
•
Enter the information and then press ESC or press ESC directly.
Here you have the option to save additional notes or information (e.g. the registration number) for
the print-out.
• Use ▼ to select upper or lower case letters, numbers or special characters.
The selected mode is shown at the top-right. Upper case letters are selected in this example.
• Use ▲ to select the preferred value.
•
Press ENTER to confirm your selection.
•
Press ESC to delete your last entry.
•
Press the ESC key twice in quick succession to cancel the print job.
•
Press the ENTER key twice in quick succession to start the print job.
" L OA D T E S T " M E N U I T E M :
Select the "Load test" menu item to check the drop in voltage when starting the engine. The voltage
in a 12-volt system should not fall below 9.6 volts. After selecting the menu item, the following will
appear in the display:
22