Werbung
Verfügbare Sprachen
Verfügbare Sprachen
D E S C R I P T I O N
Suitable for heavy-duty day-to-day work in the workshop.
•
Makes the replacement of e.g. wheel bearings, gearshaft bearings,
rubber bushes etc. much easier
•
Large working range thanks to 9-fold adjustment of support surface
•
Compression force can be read off on a large dial from 0 to 20 tons
•
Working range: 0 - 910 mm
•
Stroke: 185 mm
•
Working pressure max.: 20 tons
F E AT U R E S
•
Used for parts straightening, bending and pressing.
•
Multi-position bed for work height adjustment.
•
With air pump can reduce labor and improve working efficiency
WA R N I N G
•
This press is designed and intended for use by properly trained and experienced personnel only.
If you are not familiar with the proper and safe operation of a hydraulic press, do not use until
proper training and knowledge has been obtained.
•
Do not operate this press beyond it rated capacity.
•
DO NOT compress springs or other objects that could be ejected from the press.
DO NOT compress objects that could shatter.
•
Please understand the max. working stroke before operate, Do not overload the max. working
stroke, so as not to damage parts.
•
Check the press for loose or damaged parts before each operation. Replace damaged parts and
tighten all loose bolts before operating.
•
Some parts being pressed may have a tendency to pop out of the press or explode
under pressure. Protect yourself accordingly
M A N UA L
1.
Place work piece on bed frame.
2.
Locate and close release valve.
3.
Pump handle until the ram nears work piece.
4.
Apply load to work piece by pumping handle. Do not overload work piece.
5.
Remove load from work piece by turning release valve. Stabilize work piece so it does not fall
while pressure is released.
6.
Remove work piece after ram is fully retracted.
2 0 3 2 0 L
6
Werbung
