Confi Guring The Software And The Computer; Uninstalling The Driver And Confi Guration Program; Support And Contact Information - Hama 00062768 V2 Bedienungsanleitung

All manuals and user guides at all-guides.com
5. Confi guring the software and the computer
After you have successfully installed the network adapter, you still have to install or confi gure a protocol. This
protocol governs the data exchange between the computer and the network. TCP/IP is most common. Each
computer has to be assigned its own address for the protocol. Automatic address assignment is only reliable
if a DHCP server exists in the network, e.g. a router or access point. If you have one of these devices with a
DHCP function, you should leave the setting on "Get automatically".
Proceed as follows to check the settings on your PC:
Start => Settings => Control Panel => Network connections
Select the connection (network adapter) via which your PC is connected to the router, e.g. "LAN connection".
When you right-click the corresponding connection, a menu is displayed in which you select Properties.
Select the Internet Protocol (TCP/IP) entry in the list and click Properties.
Select Obtain an IP address automatically and Obtain DNS server address automatically, if there is a DHCP
server in your network! Confi rm by clicking OK, and again in the subsequent window.
Your PC is now confi gured such that the router assigns the IP address automatically.
If you do not have one of these devices, you must assign the IP addresses manually. The following example
describes basic setup using manual address assignment. For local networks, special address ranges are pro-
vided which are not transmitted over the internet. As an example, a range that you can use for your network
is 192.168.1.1 to 192.168.1.254. The fi rst PC is assigned the address 192.168.1.1, the second 192.168.1.2, the third
192.168.1.3, etc.
Select Use the following IP address and enter your IP address in accordance with the sample.
1.PC = IP address 192.168.1.1 Subnet mask 255.255.255.0
2.PC = IP address 192.168.1.2 Subnet mask 255.255.255.0
Click Ok to confi rm your entries.
26
6. Uninstalling the driver and confi guration program
Switch off your PC and unplug the mains plug from the socket. Open the PC case. Remove the wireless
LAN PCI card from the PC and close the PC case again. Insert the mains plug in the socket again and start
the PC.
Select Start => Settings => Control Panel => Software
Select Atheros Client Installation Program and click Delete! At the subsequent prompt, select Uninstall
previous installation, then click Next. Click OK to confi rm the uninstall.
The program then asks whether you want to delete the driver and profi les. Confi rm with Yes, if you are sure
that you want to remove the network device from your computer.
After the software is removed, the system must be restarted. Save all open documents and close all pro-
grams. Then click OK to restart the computer.
The uninstall process is complete when the computer restarts.

7. Support and contact information

If products are defective:
Please contact your dealer or Hama Product Consulting if you have any product claims.
Internet / World Wide Web:
Product support, new drivers or product information can be found at www.hama.com
Support Hotline – Hama Product Consulting:
Tel. +49 (0) 9091 / 502-115
Fax +49 (0) 9091 / 502-272
E-mail: produktberatung@hama.de
Note:
This product may only be used in Germany, Austria, Switzerland, France, England, Belgium, Spain, Holland,
Denmark, Hungary, Poland, Sweden, Luxemburg, Ireland, Greece, the Czech Republic, Slovakia and Finland.
See www.hama.com for the declaration of conformity with R&TTE Directive 99/5/EC.
27