Custom - Wireless Access Point; Change Settings - Panasonic TX-24FS503E Hilfe

Custom - Wireless Access Point

You can use the TV as a wireless access point and connect the network
equipment without an access point.
Confirm the PIN code, network settings of the equipment before starting
●
setup. For details, read the manual of the equipment.
1. Display the menu with MENU.
2. Select Network >
and press OK to access.
3. Select Connect to device in WPS
To set manually, select
●
4. Select and set WPS(Push button)
WPS(Push button):
Set up the equipment for
manual of the equipment.
WPS(PIN):
Enter the PIN code of the equipment.
If the connection fails, check the settings and positions of the
●
equipment. And then, follow the on-screen instructions.
■

Change settings

You can set up Network
Channel setting method
Follow the on-screen instructions and set manually.
Set Reset settings
●
= Note =
You cannot connect the internet service while the TV is set to
●
Access Point.
You can connect up to 7 devices. But the transfer rate varies according to
●
communication environment or the numbers of connected equipment.
To confirm the current network settings
●
Network > Network settings > Network Status
Ensure the equipment to connect supports WPS for this setup.
●
WPS: Wi-Fi Protected Setup™
●
Network Connection
and press
Change settings
/ WPS(PIN)
WPS(Push
Name(SSID), Encryption
manually.
to reset the items for
- 167 -
> Custom > Wireless Access Point
OK to access.
(see below).
and press OK
button). For details, read the
key, Wireless type
Change settings.
to access.
and
Wireless