– Select
User defined
– If you set to
SingleCable
(depending on the Single Cable router you use). For details, read
the manual of the Single Cable router.
Watching > Tuning and editing channels > Selectable satellites
5. Press
BACK/RETURN
6. Select
Auto Setup
7. Select
Search Mode
8. Set the item and press
Scan Mode
●
Quick:
Scans the suitable frequency for the selected satellite.
Full:
Scans the whole frequency range.
After settings, select
●
9. A confirmation screen is displayed and press
(Settings are made automatically.)
When the operation is completed, the channel at the lowest position will
●
be displayed.
■
DVB-C, DVB-T, Analogue
1. Select
Auto Setup
2. Set
DVB-C Auto Setup Settings
Scan Mode
●
Quick:
Scans the suitable frequency in your country.
Full:
Scans the whole frequency range.
Normally set Frequency,
●
is not displayed or if necessary, enter each value specified by your
cable provider with
After settings, select
●
to set
Test Transponder Frequency
Single
Cable, additional settings are required. Set
Version,
User
Band,
to store.
and press
OK
to access.
/
Scan Mode
and press
OK
to store.
Start scan
and press
and press
OK
to access.
and press
Symbol Rate
Numeric
buttons.
Start scan
and press
- 96 -
User Band Frequency
OK
to access.
OK
to search.
OK
to start
Auto
OK
to store. (DVB-C)
and
Network ID
to Auto. If
OK
to search.
manually.
and
PIN
Setup.
Auto