Cambro CAMSHELVING MS3030V/S Montageanleitung Seite 4

C A M S H E LV I N G
PLEASE READ DIRECTIONS BEFORE BEGINNING ASSEMBLY.
PROPER ASSEMBLY REQUIRES USING A RUBBER MALLET – DO NOT USE A METAL HAMMER!
C. T O A D D - O N A U N I T I N A S T R A I G H T L I N E
1 Assemble first unit as described in step (B).
2 Assemble another Post Kit as described in step (B1).
3 Mount traverse between Post on first unit and additional Post Kit.
The traverses on the first and second unit share the middle Post.
4 D e t e rmine if unit is level. If necessary, adjust leveling foot using a 24 wre n c h .
5 Place shelf plates on traverses.
MOUNT ADD-ON UNIT
D. T O A D D - O N A U N I T I N A 9 0 ˚ C O R N E R
1 Assemble first unit as described in step (B).
2 Assemble another post frame as described in step (B1).
3 Identify right and left Corner Connectors and mount on traverses of first unit.
To mount Corner Connectors:
a. Insert top edge of Corner Connector into groove on top edge of traverse.
b. Snap Corner Connector around bottom edge of traverse.
c. Move Corner Connector to appropriate location on Traverse to match width of second unit.
4 Repeat mounting a right and left Corner Connector on each shelf of first unit.
5 Mount Traverses between Corner Connectors and additional Post Frame.
a. The Traverses click on to the Dovetail on the Corner Connectors just like they click onto the Dovetails on the Posts.
6 D e t e rmine if unit is level. If necessary, adjust leveling foot using a 24 wre n c h .
7 Place shelf plates on traverses.
SNAP CORNER CONNECTOR
ON TRAV E R S E
A S S E M B LY INSTRU C T I O N S
®
MOUNT TRAV E R S E S
Page 2
5
SINGLE UNIT AND ADD-ON UNIT ASSEMBLED.
MIDDLE POST IS SHARED BY BOTH UNITS
CORNER CONNECTORS
CAMBRO Co rner Connectors
Helpful Hints
• Maximum weight capacity
for shelves connected with
C o rner Connectors is 180 kg.
• Traverses connected with
C a m s h e l v i n g ® C o rn e r
Connectors should be 120 cm
or short e r.
• If connecting traverses of
d i ff e rent lengths, mount the
C o rner Connectors onto the
longer traverses and mount
the shorter Traverses onto the
C o rner Connectors.