Cambro CAMSHELVING MS3030V/S Montageanleitung Seite 3

C A M S H E LV I N G
PLEASE READ DIRECTIONS BEFORE BEGINNING ASSEMBLY.
PROPER ASSEMBLY REQUIRES USING A RUBBER MALLET – DO NOT USE A METAL HAMMER!
B. T O A S S E M B L E S I N G L E U N I T
1 Assemble Post Kits
a . Hold two Posts with dovetails facing each other.
b . Mount bottom Post Connector on the two Posts using a rubber mallet, following directions on arro w.
Tap each side alternating until connector is firmly in place.
c . Mount top Post Connector on top of the two Posts.
A l t e rnate tapping each side until connector is firmly in place.
d . Repeat for second post frame.
MOUNT BOTTOM POST CONNECTOR
2 Mount traverses
a . Select shelf placement.
b . Mount traverses on posts:
1 . Align the bottom of the traverse dovetail opening with the bottom of the dovetail on the posts.
2 . P ress the traverse against the posts.
3 . Lower the traverse down.
4 . S e c u re into position by tapping both ends of the traverse with a rubber mallet.
c . Mount traverse on opposite side of post frame. Repeat for all shelves on the unit.
3 D e t e rmine if unit is level. If necessary, adjust leveling foot using a 24 wre n c h .
4 Place shelf plates on traverses.
Refer to Shelf Plate Set Configurations on back page of these assembly instru c t i o n s .
MOUNT TRAVERSES ON POSTS
A S S E M B LY INSTRU C T I O N S
®
MOUNT TOP POST CONNECTOR
RIGHT END TRAV E R S E
Bottom of the traverse
dovetail opening
Bottom of dovetail
on the post
ALL TRAVERSES MOUNTED
Page 1
4
POST AND POST CONNECTORS
A S S E M B L E D
L E V E L I N G
F O O T
PLACE SHELF PLATES
ON TRAV E R S E S