How To Charge - Ledwood ACCESS10 Bedienungsanleitung

HOW TO CHARGE

1 The charger is included in the package. Please use a standard 5V/1-2A Micro USB charger
to charge this device.
2 User may also charge the speaker via a PC, put the provided charge cable into the charge slot
of unit, connect the other end to the PC.
3 Charge time should be 2-3 hours. The orange LED turns off when fully charged.
4 When battery voltage is low, the speaker will prompt for recharging.
TWS FUNCTION
1 Turn on two identical speakers you want to pair, both under BT mode. Only need to set one
of the two units.
2 Double click on the press/pause button, speaker will make a tone and start to pair, a tone will
be audible again and LED will keep lighting after paired successfully.
3 Make Bluetooth connection with your mobile phone to play music by the two paired Speakers
to create more powerful surround sound effect.
4 When you want to exit the TWS mode, turn off the speaker or connect it to another Bluetooth
source.
5 Once two units paired with TWS, when they both are turned on next time within effective
range, they will be automatically paired again (When two units TWS connected, if you manual-
ly operate to disconnect the TWS connection, next time when you turn on the two units, they
will not automatically paired again).
PLAYING MUSIC FROM USB DISK
1 Turn the Power button to "ON".
2 Insert USB flash disk into slot, the speaker will play the stored music automatically.
3 Under playing mode, long-press Volume +/- buttons to select songs you like, short-press to
adjust the volume up and down.
4 Short-press Play/Pause to play or pause.
Remark Under Bluetooth playing mode, insert USB disk will disconnect the Bluetooth and swit-
5