Battery Replacement - Chal-Tec electronic.star 10007109 Bedienungsanleitung

If you are using any WildSpy Cam Night Vision models and like to increase more illumination by adding IR
booster, an easy way is for you that you can connect the camera and booster directly. In this case, the
gooseneck adaptor will not be required for installation. Before connection, the booster will be required to
change the trigger source for the CABLE firstly. You can open the inner panel by loosing 3 screws and will
see the Option Jumper inside the panel. See Fig.2 .
Then resume the inner panel and proceed the proper connection with the attached cable. One plug is
inserted to the IR-IN port on booster and the other plug is inserted into the IR-EXT port on camera.
3. Work with More IR Extenders
In case you expect to have much illumination in order to get extreme best quality images or videos, you can
st
connect a chain of boosters up to 4 sets as you like. For the Master booster (the 1 booster), there is no
need to change the default setting except you are using WildSpy IR camera which using cable connection.
For other slave extenders, they are required to open the inner panel by loosing 3 screws and change the
jumper for the trigger source to CABLE (Pins 2-3). See Fig.2 .Then use the attached cable to plug one end
to the IR-IN port on the slave and other end to the IR-OUT of the Master. In the chain connection, the
previous unit is called Master and the next is called as Slave.
Mounting
The booster is mounted on a tree with the attached belt as the installation method shown as the right. And
then adjust a desired angle along with the scouting camera lens direction.

Battery Replacement

The average life of good quality battery Conditions affecting battery life are including usage of the booster in
video mode or using product in a cold climate. Do not try to mix old and new batteries together.