Kit List; Operation - Chal-Tec electronic.star 10007109 Bedienungsanleitung

This kit package are including the accessory parts:
1. Main Unit x1 set
2. Gooseneck IR Sensor x1 pcs
3. Cable x1 pcs (Reserved for WildSpy IR Camera or become a slave extender)
4. Belt x1 pcs
5. Instruction sheet x1 pcs
The power is required 2 pcs good quality D cell Alkaline batteries for the best result. After installing
batteries into the compartment according to the polarity mold on the cabinet, push the Bat-Check button
once and see if an instant RED-GLOW will be viewed in a dark place in order to prove the booster is working
correctly.
Release the stopper from a port on the lower portion of booster panel and plug the cable of the
gooseneck IR sensor into the IR-IN port which is the default for a trigger source from IR sensor. The other
IR-OUT port is reserved for another IR Booster extension. See Fig. 1
After installation procedures, do not forget to check if the door is closed completely and the other rest port
is still remaining corked by a stopper before left.
1. Work with A General IR Camera
Since above installation is done, no more adjusting will be required. With the default setting, the snap stand
of gooseneck IR sensor must be required snapping on the camera and the IR sensor head always face and
be very closed to the IR light source of camera. It will always work with your scouting camera synchronously
at night time.
. Work with WildSpy IR Camera
2

Kit List

Preparation

Operation