Technical Information - Bellman & Symfon Visit BE1441 Bedienungsanleitung

76
Troubleshooting
Most problems with the flash receiver can be solved quickly by following the advice be
If Try this
Nothing happens.


The receiver is not activated.



The receiver signals when

no transmitter is activated.

Technical information

Power supply
Mains power 7.5 V DC / 1500 mA
Note: Only use the supplied power adapter.
This product is also designed for IT power distribution system with
phase to phase voltage of up to 230V. The socket-outlet shall be
installed near the equipment and shall be easily accessible.
Battery backup For BE1441: not applicable
For BE1442: 4x1.2V Lexel 600/900mAh
For BE1443: 4x1.2V Lexel 900mAh
Please dispose used batteries at municipal collecting points or
dispense them to local stores free of charge.
Radio function
Power consumption Active current: 900mA idle current: 10mA
Radio frequency 314.91/433.92/868.3 MHz depending on region
Check that the power supply unit is connected
correctly. The power LED should light up green.
Check that there is current in the wall socket.
Check the battery in the transmitters.
Check that the receiver is not placed too far away
from the transmitters by moving it closer to the
transmitters.
Check that the receiver is set to the correct radio
key. For further information see Radio key.
Change the radio key on all units in the system. For
further information see Radio key.
Number of Radio Keys
low.
Coverage
Additional information
Programming pin (16)
Activation
Radio
Via analogue telephone nw.
BE1441/BE1442
Warning! The telephone port of the Flash receiver must be connected using 26 AWG
orgreater telecommunications wire.
Output signals
Output signals
Vibrator power
Environmental requirements Operating temperature: 0°C – 35°C
Dimensions Ø x H
Weight
Colour
Optional accessories
64 Radio Keys as standard. Special software can be used to
increase these to 256 Radio Keys in increments of 64 per software
purchase. Contact the nearest supplier for further information.
The normal coverage between a transmitter and receiver in the
Bellman Visit System is up to 250 metres (868MHz)/ 80m (433MHz)/
50m (314.91MHz) with clear line of sight. Coverage is reduced
if walls and large objects screen off the signals. Any thick walls
constructed of reinforced concrete will greatly affect coverage.
The system may also be affected by radio transmitters such as TV
transmitters, computers, mobile phones, etc. This means that a unit
may work perfectly in one part of the room but not at all in another.
For service personal only (Output: 3.3V/max. 150mA)
Caution: Do not use, unit will be damaged when used.
Visit system
26 - 120 V RMS, 15 - 100 Hz.
Via the Mobile phone detector, see the accessories section
( Output: 3.3V/max 150mA)
Built-in flash light signal ~30 Candela
Warning! Flashes can trigger epileptic seizures.
2.0 – 4.0 VDC (max. 500mA)
Transport and storage temperature: -10°C – 50°C
Relative humidity: 15% - 90%, non condensing
BE1441: 70 x 140 mm
BE1442/BE1443: 78 x 155 mm
308 g, 10.8 oz (three models)
White
BE9075 Wall mount bracket
BE1270 Bed shaker
BE9105 Telephone flex cable
BE9250 Mobile phone sensor
Adapter plug for the appropriate country
77
CZ
DE
DK
ES
FI
FR
GB
GR
HU
IT
NL
NO
PL
PT
SE
SRB
APP