Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. TRANSPORT, PACKAGING AND STORAGE
3.1 Inspection after transport
Verification of the absence of damage and the integrity of the device must be carried out upon receipt of the
package. In the event of identification of damage due to transport, refuse or accept the product delivered only
under reserve *. A complaint detailing the defects observed must then be made. The perception of damages
is only possible in the event of a complaint formulated within the time limits provided, ie 24-48 hours at the
most.
* written on the right paper or digital delivery from the carrier.
3.2 Packaging
The packaging of the device must be kept in the event of a move, or for a return to the after-sales service.
The interior and exterior packaging must be completely removed before using the device. The standards in
force in your country concerning the protection of the environment must be respected before destroying the
packaging.
3.3. Storage
WARNING
The storage of the device in stock can be done but only in its original closed packaging.
Storage can be carried out under these conditions:
• Storage in a dry, non-humid place
• Sheltered from the sun
• Control of stock for more than 2 months (general condition of the device and all the elements that make it
up)
• No material shaking
• Storage in a closed room and not outside.
4. MATERIAL CHARACTERISTICS
* Subject to change
Model
Temperature
Electrical data
Dimensions
Weight
5. INSTALLATION AND USE
5.1 Safety instructions
ELECTRICAL HAZARD
Danger due to electric current!
• No contact with heat sources should take place with the electrical cord.
• The cord should not hang over the edge of a table or counter.
• Do not pour water into an appliance that is in operation or still hot.
• The device must be properly connected and comply with the regulations in force.
CPVGN11
40°C-100°C
450W / 230V
W 580 x D 400 x H 70 mm
5.25Kg
CPVR45
40°C-100°C
450W / 230V
Ø 450 x H 70 mm
4.25Kg
EN
Werbung
Kapitel
Inhaltsverzeichnis
