V. Brøndum Easy Clean NT Gebrauchsanweisung Seite 26

Inserting and Removing Micro SD Card
(See picture, page 7)
The Easy Clean Recordable Camera System is compatible with microSD, microSDHC, and
microSDXC memory cards with a capacity of up to 64GB. We recommend using a microSD
card with a minimum rating of Class 10 or UHS-I.
Insert the MicroSD Card:
Slide the memory card into the slot with the label facing the monitor.
Remove the MicroSD Card:
Push your fingernail against the edge of the memory card, and push gently. Once released,
the card will spring out slightly, allowing it to be removed.
Ensure protective flap is securely closed.
NOTICE: Use extreme care when handling memory cards. Avoid liquids, dust and debris.
As a precaution, power off the camera before inserting or removing the card.
Powering ON & OFF
The monitor and camera system come already paired. Once both systems are turned on, the
monitor will automatically display the picture transmitted by the camera.
Camera: Power ON
Remove the protective rubber boot. Press and hold the POWER ON button at the back of the
camera. Power indicator light will flash green to indicate "Power On" and continue to flash
intermittently whilst in use. Put the protective rubber boot back in place.
Camera: Power OFF
Remove the protective rubber boot. Press and hold the POWER ON button at the back of the
camera. Power indicator light will go out.
Monitor: Power ON
Press and hold the POWER / LIGHTS button on the monitor.
The power indicator light will display a red light.
The monitor will display:
1. NO SIGNAL icon if camera is switched off.
2. View from camera, if camera is switched on.
Easy Clean Kamerasystem / Camera System NT 25