Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
If in doubt about how to install the device correctly, please contact
an expert or a specialist workshop and let them do the installation!
Improper installation damages the plug-in unit as well as your com-
puter and all connected devices.
Proceed with caution. Danger to life!
Switch off the computer in which the product is to be in-
stalled and all connected devices. Disconnect all devices
from the mains voltage and pull out the mains plug! Just turning off
at the on/off switch is not enough!
Open your computer's housing and carefully remove the cover.
Look for a free 3.5" installation slot and remove the slot cover.
Often there is a metal shielding behind it, which must be removed
first. With some casings, you must unscrew this, with others you
must break it out carefully. Depending on the casing, you may have
to remove the entire front cover first.
Apart from the slot cover that is already mounted on the slot, the
scope of delivery includes two more front covers in different colors.
Depending on the existing computer housing, the slot cover can
easily be replaced by another one. Now you can install Card Rea-
der like a Floppy Disk Drive into empty slot.
Connect the 9-pin USB plug to an internal USB port on the main-
board. It is imperative to observe the correct orientation (see ope-
rating instructions for the mainboard) since a wrong connection
may damage both the mainboard and the electronics of the 3.5"
plug-in unit, loss of warranty (refer to below photo)!
9
Werbung
Inhaltsverzeichnis
