AsViva Red Neck GL2 Montageanleitung Seite 36

Attention!
Turn 2-3 times so that the screw grips on its own and connects all elements loosely. The
screws must only be driven in tightly when all elements are connected with each other in
this way. Otherwise the setup won´t be possible. Only by driving them in tightly afterwards,
small deviations of the borehole or the welded joints, which always occur with
handcrafted products, can be compensated.
Notes on an optimized assembly:
Before you completely tighten the screws, check carefully all the screws and tighten
them (only) to the extent that the product remains (especially chairs or loungers) still
under load. If you are sure that your product can withstand load, place it on a solid, level
ground and put some weight on it, please carefully and always with cushions. The various
components can then align with each other. Then tighten completely the screws. Thus
some weight.
Your new product was made by hand.
Slightly irregularities are rather seen as a
quality attribute than as a reason for
compliants.
Tip: Always fully insert the hex key inside
designated notch of screw.
If you don´t do that and slip out of the screw,
caused the screw head to become round
hex key anymore!
Please note that at first all screws should be inserted slightly by hand!
you achieve and optimal alignment of the product and prevent wobbling. Don't sit, find
the screw will suffer damage and it can
inside you won´t be able to find grip with the
36
ASSEMBLY
DONT´S
Don´t use this product if parts are missing,
damaged or worn down.
Don´t use any electronic tools to set up
these product. The high energy of these
electronic tools will cause screw overtighten
and therefor they won't grid.
Don´t overtighten screws or bolts. Only
tighten the screws entirely after the product
is completely set up. You shouldn't sit or
stand on it.
All manuals and user guides at all-guides.com Don´t let your product stand in the rain.
Protect it from weather impacts. In times of
freeze and over the winter, we suggest you
to store the product in a covered dry place.