Hilti SJD 6-22 NURON Original Bedienungsanleitung Seite 31

5.8 Fall arrest 7
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
▶ Do not secure a tool tether to the belt hook. Do not use a belt hook to lift the product.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only the Hilti tool tether #2261971.
▶ Use the loop to secure the tool tether to the product as shown in the illustration. Check that it holds
securely.
▶ Secure the carabiner to a load-bearing structure. Check that the carabiner holds securely.
Comply with the operating instructions of the Hilti tool tether.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Using a dust extractor
The dust extractor reduces dust emissions, increases working safety by providing better visibility of
the cutting line and reduces exposure to dust and wood chips at the workplace.
1. Fit the guard. → page 24
2. Always use a dust extractor when working over a lengthy period with wood or materials that can cause
high dust concentrations.
6.2 Setting the cutting angle
1. Slacken the screw on the base plate.
2. Adjust the base plate to the desired cutting angle (from 0° to 45° in both directions).
▶ At the 0° cutting angle, the base plate is held in a rotation-locked position. To set a different cutting
angle, you must first pull the base plate to the rear.
▶ When you return the base plate to the 0° cutting angle, push the base plate forward again to re-engage
it in this rotation-locked position.
3. Retighten the screw.
▶ The base plate is clamped securely.
6.3 Switching on
A safety interlock ensures that the product does not start when the product is switched on first and
the battery inserted afterward.
1. Check that the lockbutton is in the middle position.
2. Press the on/off switch.
3. To lock the switch in the "on" position, then push the lockbutton to the right.
▶ The product then runs in sustained operating mode.
4. To release the lockbutton, press the on/off switch again.
▶ The lockbutton then returns to the middle position.
*2264214*
8
2264214 English 25