HOMCOM B71-048 Montageanleitung Seite 5

Fig.9
III. Adjust the work top before use
After everything are assembled, you may find the two boards of
workbench is not at the same level, and you need to adjust them with
a Phillip screwdriver before use.
If you find that board A is higher than B, you can tighten the S1,S2,
S3,S4 Or loosen the screw S5,S6.
If you find that board B is higher than A, you can loosen the S1,S2,
S3,S4 Or tighten the screw S5,S6.
Make sure you don't fix S1,S2,S3,S4 too tight, or you won't be able
to freely slide board A.
Double check the securing
nuts on the horizontal support
bars are tight to prevent side
to side movement.
(Please see Fig.11)
Workbench
-5-
Fig.10
Fig.11