Energy-Saving Tips - EBECO Cableflex 6 Montageanleitungen

5. Fastening of heating cable must be done with c/c 20 cm.
6. Perform other insulation and resistance measurements
and fill in the test report or Garantera on your smartphone.
Document the location of the cable with a photo.
MΩ
/ Ω
8. If possible, after applying screed, alternatively after floor-
ing has been laid, perform a third insulation and resistance
measurement of the heating cable. Fill in the test report or
use Garantera on your smartphone.
For tiles, wait 4 weeks after installation before turning on the heat.

Energy-saving tips!

Ebeco Cable Board is an insulation board especially designed for Cable Kit/Cableflex under tiled and natural stone
floors. It has grooves for laying the heating cable and consequently provides quick and uniform positioning of the
heating cable without the need of manually measuring centre-to-centre distances. The insulation board's properties
make the underfloor heating system extremely responsive to adjustments. Compared to the reference installation
(60s-70s house with an uninsulated floor construction of 15 cm thick concrete slab on the ground), Cable Board
provides an energy saving of up to 45%. On concrete surfaces, it can be used both in wet rooms and dry areas. On
wooden surfaces, it may only be used in dry areas and then replaces the plasterboard in the floor construction. In wet
rooms with wooden subfloors, Ebeco Thermo Board is recommended.
7. Cover the floor with a suitable floor filler. Keep in mind that
the cable must be under the sealing layer in wet rooms.
with an uninsulated floor construction of 15 cm thick
concrete slab on the ground), Cable Board provides an
energy saving of up to 45%. On concrete surfaces, it can
be used both in wet rooms and dry areas. On wooden
surfaces, it may only be used in dry areas and then
replaces the plasterboard in the floor construction. In
wet rooms with wooden subfloors, Ebeco Thermo Board is
recommended.
2 cm
Tape
Adhesive/Cable clip
EN
13