Lampa AMPEROMATIC-PRO Bedienungsanleitung Seite 8

BATTERY TEST FUNCTION:
If you connect the battery to the device, without plugging it to the power, the device will switch to the battery test mode
and it will indicate the battery charge percentage status (from 15% - 60% in red or 80% in green).
DESULPHATION INSTRUCTIONS:
1. To activate the desulfation process: connect the plug to the electric power, connect the clips properly, select the right
charging mode for GEL or AGM according to the type of battery, then press the START/CLOSE button for 3 seconds. The
moment this mode will be activated, the charge red led will start blinking. In order to cut this mode, press the START/
CLOSE button again for at least 3 seconds. If you press the button for less than 3 seconds, the process will not stop.
2. During the desulfation mode, the process will stop automatically after having charged until 14,4V.
3. ATTENTION: with LiFePO4 mode (Lithium) it is not possible to activate the desulfation process due to safety matters.
SAFETY INSTRUCTIONS
Attention: This product with charging voltage is 1-15V for 12V lead acid battery and 8-15V for 12V/12.8V LiFe-
PO4 battery.
In order to prevent you from damages, injuries, short circuits or fires due to the use of the battery charger, be sure that
you properly follow the standard safety instructions below. We recommend you to read the following instructions care-
fully before using this product and to store them for future reference.
ATTENTION:
Keep this product out of reach of children.
• Be careful to the short circuits: do not use this product near or proximate to warm areas or objects.
• Professional technical use: use this product in closed areas, do not use this product in steamed or damped areas. Use
this product in light environment but not under the direct sunlight, warm areas, snow or rain.
• Clothing: we recommend you to wear technical clothes that cannot obstruct the movements while operating with this
product, moreover we recommend you not to wear pieces of jewelry while using this product, this way you will avoid the
contact between the battery and the battery charger.
• Battery charger care: when not in use, we suggest you to store the battery charger in a dry place, at room temperature
and out of the reach of children. Technical professional usage exclusively.
• Cable protection: it is strongly forbidden to hold or take the battery charger from the cable side or to unplug the
device by pulling the cable. Keep out the cable from sharpened objects, hot areas or oils that can damage it.
• Battery charger unplug: when not in use, we recommend you to unplug the device.
• Check the evidence of damages: before using it, we recommend you to check the battery charger, the cable and the
clips in order to detect any kind of damage.
• Product repairing: for every kind of product every repairing, we recommend you to have it repaired from professional
technical staff. Do not try to force and open the battery charger body. If the clips or the cables should be damaged,
replace them before using the battery charger.
• Gas: while charging the battery, bubbles can form inside the liquid, which is due to gas formation. This kind of gas is
highly inflammable, therefore we suggest you to avoid making flames while charging the battery and to keep ventilated
the area. In order to avoid the risks of explosion, we recommend you to remove the elements of the battery before
connecting the plug to the power, viceversa we recommend you to put back the elements for the battery after having
disconnected the battery charger from the power.
WARNING
DO NOT TOUCH THE ELECTROLYTES WITHOUT PROPER PROTECTIVE CLOTHES. IT IS ACID AND IT CAN CAUSE BURNS.
SHOULD YOU TOUCH THE ACID AND GET BURNED, WASH THE INJURED AREA WITH WATER IMMEDIATELY.
8