Bowers DigiMic Bedienungsanleitung Seite 12

6. Standby
This reduced consumption mode works without the loss of the reference position. Standby mode activates
after 10 minutes of no use, or by holding the [SET] button until the screen goes blank.
Standby mode deactivates on detected movement, button pressing or communicating with Bluetooth de-
vices.
7. Full Switch OFF
To switch the device fully off, press and hold the [SET] button until the device shows (--OFF--).
In this state no data is maintained and therefore the reference position is lost. The (--SET--) message will be
displayed again during next use (See switching ON).
12