Bellman & Symfon BE1450 Gebrauchsanweisung Seite 34

66
Appendix
Settings
No adjustments are required for normal use. The relevant descriptions are provided below, if
you wish to change a setting for some reason.
Radio key
In order to use several Visit systems close to one another without interference, different radio
keys can be set on the different systems. All Visit system units are supplied from the factory
tuned to the same radio key, channel 0. This means that all radio key switches on the trans-
mitters are set to the OFF position.
A Visit transmitter is also required to alter the radio key on the portable receiver. Proceed as
follows to change the radio key:
1 Set the transmitter to the desired radio key by altering its radio key switch to the desired
radio key. See the transmitter user manual for further information.
2 Hold down the test button (12) on the portable receiver until the green (5) and yellow (6)
LEDs blink alternately. The portable receiver will now be in programming mode for about
30 seconds.
3 Press the test button on the transmitter. The LEDs (4, 5, 6 and 7) will now blink five times
in quick succession to indicate a successful change of radio key.
3 After changing the radio key, the portable receiver will automatically return to normal
mode.
Please note: all Bellman Visit products within the same system must be tuned to the
same Radio Key in order to operate as a group.
Signal pattern
GB
A signal pattern is the name for the way in which a receiver in the Visit system indicates
activation. Changing signal switch on the transmitter changes the signal pattern which the
receivers display when the transmitter is activated.
The following signal patterns are available for the Visit system.
Type LED pattern
Green 1 Green constant light
Green 2 2 x green blinks
Green 3 3 x green blinks
Green 4 Blinking in green
Yellow 1
Yellow constant light
Yellow 2 2 x yellow blinks
Yellow 3 3 x yellow blinks
Yellow 4
Blinking in yellow
Orange 1 Orange light
Orange 2 2 x orange blinks
Orange 3 3 x orange blinks
Orange 4 Blinking in orange
VMA
Blinks in red & orange
Fire alarm Blinking in red
Fire low bat. Blinks in red every 5s
Fire flat bat. Blinks in red every 5s
LED blink, LED off,
Sound
1 x ding dong, LF
2 x ding dong, LF
1 x ding dong, HF
2 x ding dong, HF
1 x ring LF
2 x ring, LF
1 x ring, HF
2 x ring, HF
Baby melody
Baby melody
Baby melody
Baby melody
VMA constant
Fire alarm constant Long
No sound
One short alarm
Constant LED light, Vibration, Pause, HF High Frequency, LF Low Frequency
67
CZ
DE
Vibration pattern
Flash
DK
Slow Yes
Slow ES
Yes
Slow Yes
FI
Slow
Yes
FR
Medium Yes
Medium Yes
GB
Medium
Yes
GR
Medium Yes
HU
Fast Yes
Fast
Yes
IT
Fast Yes
NL
Fast
Yes
NO
Long Yes
Yes
PL
None
No
PT
One short Yes
SE
Srb
App