Suitable Microwave Tableware; Notes On Operating And Using The Appliance; What You Should Know About Microwave Operation; Notes On Operating The Appliance - Profi Cook PC-MWG 1176 H Bedienungsanleitung, Garantie

Suitable Microwave Tableware

• The ideal material for use in a microwave is transparent and allows
the microwave radiation to heat the food evenly.
• Round / oval dishes and plates are more suitable than rectangular
ones as the food in the corners may overcook.
CAUTION:
Risk of explosion by sealed tableware.
• Open closed containers before cooking or heating.
• Pierce protective plastic foil several times using a fork.
CAUTION: Sparking and Fire Hazard!
• Microwaves cannot penetrate metal. Accordingly, no metal contain-
ers or plates may be used in microwave operation.
• Do not use any paper dishes made of recycled material as these
may contain small amounts of metal, which may result in sparks or
fires.
The list below is intended to help you select suitable microwave table-
ware:
Material

Microwave Grill

Heat-resistant glass vessel
Non-heat-resistant glass
vessel
Heat-resistant ceramic
vessel / plate
Plastic vessels suitable for
microwave use
Kitchen roll
Grilling grid
Metal or aluminium ovenware
Aluminium foil and foil con-
tainers
*) Microwave + grill or microwave + convection combination modes

Notes on Operating and Using the Appliance

What you Should Know about Microwave Operation

• Your appliance works with microwave radiation, which heats up water
particles in food in a very short time. There is no heat radiation and
therefore hardly any browning.
• Only food should be heated up with this appliance.
• The appliance is not suitable for baking in floating fat.
• Only 1 - 2 portions should be heated up at the same time. Otherwise
the microwave will become less efficient.
• Microwaves provide their full energy levels immediately. Pre-heating
is therefore not necessary.
• Never operate the microwave function when the oven is empty.
• The microwave oven does not replace your traditional cooker. It is
used mainly for:
- defrosting deep-frozen food
- rapid warming / heating of food or drinks
- cooking meals.

Notes on Operating the Appliance

• Your selection by pressing buttons is confirmed by a signal tone. If
this does not occur, then you have not pressed the button properly or
you have made an incorrect selection.
• If a program is selected and the START button is not pressed within
2 minutes, then the setting is cancelled. The display will then show
the current time again.
60
PC-MWG1176H_IM
Suitable for
Con- Combi-
vection nation *
yes yes yes yes
no no no no
yes yes yes yes
yes no no no
no no no no
no yes yes no
no yes yes no
no yes yes no
• After a program has started, the display will show a countdown timer
indicating the remaining operating time.
• 3 signal tones will indicate the end of the program. "
in the display. After that the appliance turns off automatically.
• The illumination inside the microwave oven is on permanently. Close
the door of the microwave oven to turn off the illumination.

Initial Operation

Installation Instructions

• Install the appliance with the back of the appliance facing the wall.
• Maintain the following safety clearances:
- 10 cm to the back
- 5 cm to both sides
- 20 cm to the top of the microwave.
• In order to avoid interference with the operation of other appliances,
do not place your appliance near other electronic appliances.

Preparation

1. Use the handle to open the door.
2. Remove any accessories from the cooking chamber and unpack.
3. If not yet done: Place the drive shaft on the centre of the bottom
inside the oven.
4. Install the guide ring in the centre.
5. Position the glass rotating plate in such a way that its lower recesses
lock onto the centre of the drive shaft.
6. Check the appliance for any visible damage, particularly in the area of
the door. If any damage is found, the appliance must not be used.
7. Make sure the mains voltage to be used corresponds to the voltage
of the appliance. Check the rating label for specifications.
8. Insert the mains plug into a properly installed power socket.
CAUTION:
• Do not remove any installed parts from inside the oven or from
inside the door!
• The mica sheet (11) is also part of the appliance and must not be
removed. It protects the electronic component located behind it
from dirt.
NOTE:
If there are manufacturing or oil remains on the enclosure or heating
element, smoke or odour might occur during the beginning operation.
This is normal and will cease after repeated use.
We strongly recommend proceeding as follows:
• Turn on the grill mode and let the appliance operate several times
without food to be cooked.
• Ensure sufficient ventilation.

Setting the Clock

NOTE:
As soon as the appliance has been connected to the power supply, all
segments light up 3 times. Then a signal will sound and in the display
will flash " ".
1. Press the TIMER / CLOCK button once.
2. Use the rotary knob to set the desired hour.
3. Press the TIMER / CLOCK button to confirm your settings.
4. Use the rotary knob to set the desired minutes.
5. Press the TIMER / CLOCK button again to activate the new time. The
delimiter symbol " "of the digital time will be flashing on the display.
" will appear
17.04.19