Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mirror assembly instruction
1. The IP44 standard allows for the mirror to be instal-
led in zones 2 and 3 of the bathroom, i.e. in close
proximity to the bathtub, shower cubicle and wa-
shbasin, defined in the area of up to 60 cm in each
side and in the further vicinity of sanitary facilities,
designated in an area with a width of 2,4 m.
2. No tools are needed for the installation.
3. The mounting plates included are equipped with
a very strong double-sided 3M adhesive tape.
4. It is recommended to install the mounting plates on
clean, dry and smooth surfaces, such as mirrors, ti-
les, metal, ceramics.
5. Plates cannot be applied to rough, uneven or crum-
bling surfaces, e.g. wood, plaster, painted surfaces,
raw.
6. Before sticking them to the target surface, make sure
you select the planned space for installation.
7. The sticky mounting plate may be difficult to remo-
ve/peel off. Use tools and appropriate fluids to dis-
solve the glue.
8. Mounting the mirror to the previously glued plate
must be slow and gentle due to the strong magnet
mounted in its housing.
9. The mirror should be mounted on the plate so that
the entire surface of the mounting base adheres to it
evenly.
10. The appliance is intended for private, domestic use
only, and is not suitable for commercial purpo-
ses.
Product disposal
Packaging elements in the form of cardboard, pa-
per and similar materials should be transferred
to waste paper or thrown into waste paper con-
tainers.
The EPE foam box filling is 100% recyclable. Pla-
stic components, such as foil, should be thrown
into containers intended for plastics.
Worn out or damaged mirror light fitting and po-
wer supply must not be disposed of with ordinary
waste. They should be handed over to the ap-
propriate electrical and electronic waste disposal
plant.
1
2
3
4
7
Werbung
