KIDOMO F02 Bedienungsanleitung Seite 7

EN
READY TO FLY
Note:
① Make sure the propellers and protective covers are installed correctly and
tightened, and that the power capacity of the drone is more than 50%.
② Before flying, please set the frequency and calibrate the drone and remote
control.
1. HOW TO SET THE FREQUENCY
Step1: Turn on the power of the fuselage and place the drone on a level surface.
Step2: Turn on the power switch of the remote control.
Step3: The two LED lights at the front of the drone will flash. Push the left joystick
of the remote control to its highest point, then pull it to its lowest point. The
controller will "beep", indicating that frequency setting is complete. After
completion, the LED light at the front of the drone will be steadily lit.
Step1
2. HOW TO CALIBRATE
Move the right joystick of the controller to the lower right side and the left joystick
to the lower left (these actions should be performed at the same time). The two
LED lights at the front of the drone will stop flashing and be steadily lit. When the
controller emits a "beep", the drone lights will be steadily lit, indicating successful
calibration.
NOTE: If the drone encounters an impact or external collision, it can lead to a
deviation in direction. In this case, land the drone on flat ground to ensure that its
forward direction (the front of the lens) is consistent with the forward direction of
the controller. Then complete the calibration.
Step2
5
Step3