Werbung
All manuals and user guides at all-guides.com
batteries according to the instructions. Improper
replacement of the battery with an incorrect type
may defeat a safeguard (for example, in the case
of some lithium battery types). Do not dispose of
the battery into fire or a hot oven, or
mechanically crush or cut the battery, which may
result in an explosion. Do not leave the battery in
an extremely high temperature surrounding
environment, which may result in an explosion or
the leakage of flammable liquid or gas. Do not
subject the battery to extremely low air pressure,
which may result in an explosion or the leakage of
flammable liquid or gas. + identifies the positive
terminal(s) of equipment which is used with, or
generates direct current. - identifies the negative
terminal(s) of equipment which is used with, or
generates direct current.
Fire Prevention
No naked flame sources, such as lighted candles,
should be placed on the equipment. The serial
port of the equipment is used for debugging only.
Hot Surface Prevention
CAUTION: Hot parts! Burned fingers when
handling the parts. Wait one-half hour after
switching off before handling parts. This sticker is
to indicate that the marked item can be hot and
should not be touched without taking care. For
device with this sticker, this
device
installation in a restricted
access location, access can
only be gained by service persons or by users who
have been instructed about the reasons for the
restrictions applied to the location and about any
precautions that shall be taken.
Installation
Install
the
equipment
instructions in this manual.
Power Supply
Device
powered
Voltage(SELV): The power source should meet
limited power source or PS2 requirements
according to IEC 60950-1 or IEC 62368-1 standard.
Device powered by AC mains supply voltage: The
equipment must be connected to an earthed
mains socket-outlet. An appropriate readily
accessible disconnect device shall be incorporated
external to the equipment. An appropriate
overcurrent
protective
incorporated external to the equipment, not
exceeding the specification of the building. An
Déclaration de conformité UE
Ce produit et - le cas échéant -
les accessoires fournis sont
marqués « CE » et sont donc
conformes
européennes
applicables énumérées dans la directive CEM
2014/30/UE, la directive DBT 2014/35/UE, la
directive RoHS 2011/65/UE, dispositif Wi-Fi : la
directive RE 2014/53/UE
2012/19/UE
Dans l'Union européenne, les
produits portant ce pictogramme
ne doivent pas être déposés
dans une décharge municipale
où le tri des déchets n'est pas
pratiqué. Pour un recyclage
is
intended
according
to
by
Safety
Extra-Low
device
shall
aux
normes
harmonisées
(directive DEEE) :
all-pole mains switch shall be incorporated in the
electrical installation of the building. Ensure
correct wiring of the terminals for connection to
an AC mains supply. The equipment has been
designed, when required, modified for connection
to an IT power distribution system.
White Light Illuminator (If supported)
Possibly hazardous optical radiation emitted from
this product. DO NOT stare at operating light
source. May be harmful to the eyes. Wear
appropriate eye protection or DO NOT turn on the
white light when you assemble, install or maintain
the camera.
Transportation
Keep the device in original or similar packaging
while transporting it.
System Security
The installer and user are responsible for
password and security configuration.
Maintenance
If the product does not work properly, please
contact your dealer or the nearest service center.
We shall not assume any responsibility for
problems caused by unauthorized repair or
maintenance. A few device components (e.g.,
electrolytic
capacitor)
replacement. The average lifespan varies, so
periodic checking is recommended. Contact your
for
dealer for details.
Cleaning
Please use a soft and dry cloth when clean inside
and outside surfaces of the product cover. Do not
use alkaline detergents.
Using Environment
DO NOT place the camera in extremely hot, cold,
dusty or damp locations, and do not expose it to
the
high electromagnetic radiation.
Emergency
If smoke, odor, or noise arises from the device,
immediately turn off the power, unplug the
power cable, and contact the service center.
Time Synchronization
Set up device time manually for the first time
access if the local time is not synchronized with
that of the network. Visit the device via Web
browse/client software and go to time settings
interface.
Reflection
be
Make sure that no reflective surface is too close
to the device lens. The IR light from the device
may reflect back into the lens causing reflection.
adéquat, remettez ce produit à votre revendeur
lors
de
l'achat
équivalent, ou déposez-le dans un lieu de collecte
prévu à cet effet. Pour plus de précisions,
rendez-vous sur : www.recyclethis.info
précisions sur la batterie, reportez-vous à sa
documentation. La batterie porte le pictogramme
ci-contre, qui peut inclure la mention Cd
(cadmium), Pb (plomb) ou Hg (mercure). Pour la
recycler correctement, renvoyez la batterie à votre
6
require
Français
d'un
nouvel
équipement
2006/66/CE (directive sur les
batteries) : Ce produit renferme
une batterie qui ne doit pas être
déposée dans une décharge
municipale où le tri des déchets
n'est pas pratiqué, dans l'Union
européenne.
Pour
regular
plus
de
Werbung
