Vigor Equipment V7548 Bedienungsanleitung Seite 26

B. Accurate test
(1) Connect the red clamp to the positive pole and the
black clamp to the negative pole. Make sure that all
connections are well secured to ensure an accurate test.
(2) Press the < >< > button to select the test function and
then press <ENTER>. See image:
(3) Press the < >< > button to select the type of battery.
Then press <ENTER>. See image:
(4) According to the labelling of the battery, press the
button< >< > to select quick test or accurate test.
The image below shows the selection of the accurate test,
press < >< >. See image:
(5) Press the < >< > button to select the test standard
according to the standard of the battery. If it is the JIS
standard, you must check the CCA value against the
comparison table. Then select CCA (SAE) as the test
standard and press <ENTER>. See image:
26
VIGOR GmbH
[ +49 (0) 21 91 / 97 95 • \ +49 (0) 21 91 / 97 96 00 • ] info@vigor-equipment.com • ^ vigor-equipment.com
Design and function
3
• ; Am Langen Siepen 13-15 • 42857 Remscheid • GERMANY
(6) According to the label on the battery, press the button
< >< > to set the nominal value. See image:
(7) Press <ENTER> to start the test.
(8) When the test is completed, the test results are shown on
the LCD display.
(9) Press <ESC> to return to step (2) and select
another test function.