Appliance Operation; Getting Started - COLUMBIA VAC OK200 Bedienungsanleitung

APPLIANCE OPERATION

Read the entire instructions manual carefully before using the vacuum cleaner for the
first time. After unpacking the appliance, make sure that it has not been damaged during
transport. In case of any doubts, do not use the appliance until after contacting the service
station.
Before performing any installation and maintenance works, turn the appliance off
and disconnect it from the power supply.
ASSEMBLY
Before using the appliance:
- open the lid (3) by releasing the fixing clamps (7),
- remove all accessories from the container (5),
- turn the container over (5) and install the wheels (6), – Fig. 4,
- depending on the type of work (wet or dry vacuuming), install appropriate filters – see
below.
- install the drain plug (11),
- close the lid (3) securely by snapping the clamps (7),
- insert the thicker end of the hose (12) into the port (4) and lock it in place – Fig. 5.
- connect the suction pipe segments (13) and join them with the suction hose (12) – adjust
the length of the suction pipe as required,
- put the attachment (14, 15 or 16) on the other end of the suction pipe

GETTING STARTED

- the vacuum cleaner can be moved by using the handle (1),
- make sure that the appropriate filters (20, 21, 22, 23) and drain plug (11) are fitted,
NOTE! Do not vacuum without the appropriate filters installed – see below
- connect the hose (12) with the suction pipe and the appropriate attachment (14, 15 or
16) to the socket (4),
- connect the appliance to a power supply with the parameters specified in the manual,
- turn on the appliance using the switch (2),
NOTE! Do not obstruct the air outlet (9) in the lid (3) when the vacuum cleaner is
running.
- press the switch (2) to stop the appliance.
- clean the appliance after the work is finished.
Dry vacuuming
- remove the lid (3) – see "ASSEMBLY"
- install one of the following on the basket (17):
- HEPA filter (20) and secure it using the lock (19) – Fig. 6,
or
- standard canvas filter (21) – Fig. 7,
or
- increased capacity canvas filter (22) – Fig. 8,
All manuals and user guides at all-guides.com
EN|15