Safety Instructions - Worx WG151E Übersetzung Der Originalanleitung

SAFETY INSTRUCTIONS

wARNINg: Read all safety warnings
and all instructions. Failure to follow
the warnings and instructions may result in
electric shock, fire and/or serious injury.
wARNINg: Read all safety warnings
designated by the symbol and all
instructions.
Save all warnings and instructions for
future reference.
The term "power tool" in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
gENERAL POwER TOOL SAFETy
wARNINgS - wORK AREA SAFETy
1) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
2) Do not operate power tools in
explosive atmospheres, such as in the
presence of flammable liquids, gases
or dust. Power tools create sparks which
may ignite the dust or fumes.
3) Keep children and bystanders
away while operating a power tool.
10 10
Distractions can cause you to lose control.
gENERAL POwER TOOL SAFETy
wARNINgS - ELECTRICAL SAFETy
1) Power tool plugs must match the
outlet. Never modify the plug in any
way. Do not use any adapter plugs
with earthed (grounded) power tools.
Unmodified plugs and matching outlets
will reduce risk of electric shock.
2) Avoid body contact with earthed or
grounded surfaces, such as pipes,
radiators, ranges and refrigerators.
There is an increased risk of electric shock
if your body is earthed or grounded.
3) Do not expose power tools to rain or
wet conditions. Water entering a power
tool will increase the risk of electric shock.
4) Do not abuse the cord. Never use
the cord for carrying, pulling or
unplugging the power tool. Keep cord
away from heat, oil, sharp edges or
moving parts.
Damaged or entangled cords increase the
risk of electric shock.
2-in-1 cordless Li-ion grass trimmer/edger
All manuals and user guides at all-guides.com
5) when operating a power tool
6) If operating a power tool in a damp
NOTE: The term "residual current device
(RCD)" may be replaced by the term "ground
fault circuit interrupter (GFCI)" or "earth
leakage circuit breaker (ELCB)" .
1) Stay alert, watch what you are
2) use personal protective equipment.
3) Prevent unintentional starting. Ensure
4) Remove any adjusting key or wrench
5) Do not overreach. Keep proper
6) Dress properly. Do not wear loose
outdoors, use an extension cord
suitable for outdoor use. Use of a cord
suitable for outdoor use reduces the risk of
electric shock.
location is unavoidable, use a residual
current device (RCD) protected
supply. Use of an RCD reduces the risk of
electric shock.
gENERAL POwER TOOL SAFETy
wARNINgS - PERSONAL SAFETy
doing and use common sense when
operating a power tool. Do not use
a power tool while you are tired or
under the influence of drugs, alcohol
or medication. A moment of inattention
while operating power tools may result in
serious personal injury.
Always wear eye protection. Protective
equipment such as dust mask, non-
skid safety shoes, hard hat, or hearing
protection used for appropriate conditions
will reduce personal injuries.
the switch is in the off-position before
connecting to power source and/or
battery pack, picking up or carrying
the tool.
Carrying power tools with your finger on
the switch or energising power tools that
have the switch on invites accidents.
before turning the power tool on. A
wrench or a key left attached to a rotating
part of the power tool may result in
personal injury.
footing and balance at all times. This
enables better control of the power tool in
unexpected situations.
clothing or jewellery. Keep your hair
EN