Use; Service & Maintenance; Thermostat Control - Ferm EHM1002 Betriebsanleitung

EN

4. Use

Thermostat control

Fig 1.
Note:
The fan will start as soon as the equipment is
switched on. The equipment will only heat up when
the room temperature falls below the temperature
set on the thermostat and the heat output switch is
on.
Switch on the required heating output (1). Turn the
control (2) to "max" until the required room
temperature has been reached. Then turn down the
control until you hear a clear click. The thermostat
will switch the heating element on and off
automatically.
Overheating guard
In case of excessive heating, the heating function
shuts down automatically. The fan will restart. If this
occurs, turn off the equipment, disconnect the
mains plug and wait a few minutes for the
equipment to cool. After eliminating the cause (e.g.
a covered air grille), the equipment can be switched
on again.
Switching off
After the hot equipment has been switched off (by
turning the heat output switch to "0") the fan may
continue to run for a while to cool the equipment.
However, if the fan continues to run for more than
10 minutes, this is a sign that it cannot cut out
automatically because of the high room
temperature. In this case you must pull out the
power plug.
5. Service and Maintenance
cleaning
Keep the ventilation slots of the machine clean to
prevent overheating of the engine. Regularly clean
the machine housing with a soft cloth, preferably
after each use. Keep the ventilation slots free from
dust and dirt. If the dirt does not come off use a soft
cloth moistened with soapy water. Never use
solvents such as petrol, alcohol, ammonia water,
etc. These solvents may damage the plastic parts.
Storage
Store the equipment and accessories out of
children's reach in a dark and dry place at above
freezing temperature. The ideal storage
6
temperature is between 5 and 30 °C. Store the
equipment in its original packaging.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the warranty
card. In the back of this manual you will find an
exploded view showing the parts that can be
ordered.
Environment
To prevent damage during transport, the appliance
is delivered in a solid packaging which consists
largely of reusable material. Therefore please make
use of options for recycling the packaging.
Damaged and/or disposed of electrical or
electronic devices must be dropped off at
recycling stations intended for that
purpose.
Warranty
For the conditions of warranty, please refer to the
separately provided warranty card. The product
and the user manual are subject to change.
Specifications can be changed without further
notice.
Ferm