Assembly - Ferm EHM1002 Betriebsanleitung

use. If you find signs of damage, contact your
customer service center.
• Place the mains cable so that there is no
danger of tripping over the cable.
• Do not guide the mains cable over hot parts of
the appliance during operation.
• Never use the mains cable to pull the power
plug out of the socket-outlet! Never use the
mains cable to carry the appliance or try to
move the appliance by pulling the mains cable.
• Never wind the mains cable around the fan
heater.
• Never jam the mains cable between objects, or
pull the cable over sharp edges, or place the
cable over hot plates or open flames.
• Not suitable for commercial purposes.
• Use the appliance in enclosed rooms only.
• Never open the appliance or touch live parts –
danger of fatal accident!
• Never immerse the appliance in water – danger
of fatal accident!
• Do not place the appliance near wet rooms or
wet areas (bathroom, shower room, swimming
pool, etc.). It must not be possible for the
control elements to be touched by a person in a
shower, a vessel filled with liquid or the bathtub.
• Never use the appliance with wet hands.
• Position the appliance in such a way that the
mains plug is accessible at all times.
• If the appliance is not used for a longer period
of time, disconnect it from the mains supply.
• Do not position the appliance directly below a
socket.
• For supervised operation only.
• If the appliance is used for a longer time the
housing can become very hot. Position the
appliance in such a way as to prevent
accidental touching.
• Never position the appliance on deep pile
carpets.
• Do not use the appliance in rooms in which
inflammable materials (for example solvents,
etc.) or gases are used or stored.
• Keep highly inflammable substances and
gases away from the appliance.
• Do not use in areas where there is a fire risk
(for example wooden sheds).
• Only use the radiator with its mains lead fully
extended.
• Not suitable for installation on permanently
installed electrical cables.
• Do not use the appliance for animal husbandry
or livestock breeding.
• Do not insert any foreign objects in the
Ferm
appliance's openings.
• Danger of electric shock and damage to the
appliance.
• Keep children and people on medication or
under the influence of alcohol away from the
appliance.
• Maintenance and repair work may only be
carried out by authorized trained personnel.
Important! Do not cover the appliance –
fire risk!
• For electrical safety purposes provide separate
fusing for the equipment (16A) and install a
residual current device circuit-breaker (RCD).
• This equipment is not designed to be used by
people (including children) with limited
physical, sensory or mental capacities or those
with no experience and/or knowledge unless
they are supervised by a person who is
responsible for their safety or they have
received instructions from such a person in
how to use the equipment safely.
• Children must always be supervised in order to
ensure that they do not play with the
equipment.
• Do not connect the fan heater using an on/off
timer or other equipment which can
automatically switch the device on.
• If an extension cord is used, it must be as short
as possible and always be fully extended. Only
use certified 3 wired extension cords with a
minimum of 3 mm
2
minimum of 3800W

3. Assembly

Check the correct air throughput by holding a sheet
of paper at a distance of 10 cm in front of the air
outlet grille in air circulation mode (without heating).
The paper must be blown away from the air outlet
grille. When the equipment is used for the first time
or after a long period of rest it may emit an odor for
a short time. This is not a fault. Because the heating
system works with specially encapsulated heating
elements and a high air delivery rate, the emitted
air may be felt to be cooler than that from a
conventional fan heater. This is not an equipment
defect.
thickness, suitabale for a
EN
5