Bauhaus LCD SF 04 Bedienungsanleitung Seite 46

(2)Calibrating and Scanning in metal Scan
 Select metal mode
 Press and hold on/off button
 Then calibrate scanner in air. Move away from metal
objects until the sound is off
 Place scanner flat on the surface
 While holding in on/off button, slowly move unit randomly
to locate target
 LCD screen indicates proximity to metal, with center bar
indicating closest proximity
 Mark this spot
 Continue scanning beyond the marked spot to detect
width of target. If target is wide , reverse to locate and mark
the other edge
 Avoid sawing or drilling between the two marks
 Widths will vary from single peak for narrow rebar to wide
area for metal studs, I beams and junction boxes.
(3) Scanning in AC mode
Important notice!
 AC depths to about 50mm
 The scanner detects from 90V to 250 V at 50 to 60 Hz AC in
a HOT electrical wire
 The voltage detection feature works continuously in all modes
for safety
 Select AC scan mode to determine position of hot wires
 Begin by placing the scanner at some position away from hot
wiring
 While holding in the on/off button, slowly slide unit across the wall
 AC indicator will appear on LCD if a hot wire is nearby
 LCD display indicates proximity to hot wire all bars indicating
closest proximity
 Mark this mark.
GB
English 45
(2)
(3)