Bauhaus LCD SF 04 Bedienungsanleitung Seite 45

 Always replace the complete set of batteries.
Caution!
Always remove exhausted batteries from these products

Do not dispose of batteries in a fire. Batteries may explode

or leak
Do not short-circuit the battery terminals

Do not mix used and new batteries

Do not use rechargeable batteries in this product.

Do not recharge non-rechargeable batteries

Do not allow any part to come in contact with heat or a direct

flame
Do not allow water to come into contact with the batteries or

wiring
When installing batteries in the battery compartment,

ensure the batteries are placed as marked (+)(-)
Only the recommended batteries should be used

Keep this product out of the reach of small children.

Operation
Turning the power on/off
 On:: Press and hold the on/off button on left side
 Off::Release on/off button.
(1) Stud Scan or Deep Scan modes
Stud Scan mode for depths to about 18mm
Deep Scan mode for Depths to about 30mm
 Position the scanner flatly against the wall
 Select mode
 Press and hold on/off button. Sounds off the auto finish
 Slowly slide unit horizontally across wall, right of left
 When full bars appears on the LCD and steady tone sounds,
you have located the edge of the stud
 Mark this spot.
 Continue holding on/off button in and scan beyond the
marked spot until bars disappears
Without releasing on/off button, slide scanner in

reverse direction to locate the other edge of stud
 Mark this second spot. Middle of stud is centered
between the two marks.
GB
English 44
(1)