Eurotops FORECAST PROJECT Gebrauchsanweisung Seite 22

S 9358 /
KW9358W-c
Active outdoor upper temperature alert, the icon "
Active outdoor upper& lower temperature alert, the icon "
Active outdoor lower temperature alert, the icon "
Deactivate outdoor temperature alert, alert icon disappear.
Hold "ALERT" button for 3 seconds to enter outdoor temperature alert setting. Icon "

temperature's digits flash. Press "▲" or "▼"button to adjust the setting value, press "ALERT" to confirm the setting.
Setting sequence as follow: Upper limit of temperature, Lower limit of temperature.
When it's alerting, the corresponding icon "

sound.
5) Radio Controlled Clock:
After power on the clock automatically starts to scan the DCF time signal. Radio Control Icon"

flashes,
Indicating now is receiving
DCF signal
The clock automatically scans the time signal at 3.00 a.m. every day to maintain accurate timing. If reception fail, scanning

stops (" " on LCD disappear)
The clock can be set to scan the time signal manually by holding "WAVE" button for 3 seconds. Each reception takes

about few minutes.
Stop scanning by holding "WAVE" button for 3 seconds.

"DST" shown on the LCD if it is in daylight saving time mode

6) Manual Time Setting:
Hold "MODE" button for 3 seconds to enter settings, press "▲" or "▼" button to adjust setting. Press "MODE" to confirm

and move to the next setting.
The setting sequence are as follows: Weather forecast, RCC ON/OFF, Time Zone, 12/24Hour, Hour, Minute, Weekday

language, Year, Month-Day Sequence, Month, Day, Temperature Unit
10 languages can be selected in Day-of-week, they are: German (GE), English(EN), French(FR), Italian(IT), Dutch(NE),

Spanish(ES), Danish(DA), Czech(CZ), Russian(RU), Norwegian (NO)
The time zone is used for the countries that can receive the DCF time signal but the time zone is different from the

German time.
7) Daily Snooze Alarm Function:
Press "MODE" button to select to view :

Time Alarm Time ("AL" Shown on the LCD)
Hold "ALARM" button for 3 seconds to enter alarm time setting. Press "▲" or "▼" button to adjust the alarm time. Press

"ALARM" button to confirm the setting.
Press "ALARM" button to switch alarm on or off. If it is on, "

When alarm sounds, press "SNOOZE" button to activate the snooze alarm, ("

for 5 minutes, then it alarms again. This snooze function can be enabled for maximum 7 times.
Except "Snooze" button, press any buttons to stop the snooze alarm.

8) Moon Phase Display
Moon phase display would be changed base on the changing in date.
" below outdoor temperature digit would display.
" or "
turns on,
Indicating signal received
successfully
" below outdoor temperature digit would display.
" below outdoor temperature digit would display.
" would flash on the LCD. Press any buttons to stop the alert
disappear,
Indicating signal reception
failed
" shown on the LCD.
" flash on the LCD). The alarm will snooze
" or " " below outdoor
" flashes on the LCD.