Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Cutting
Wood
capacity
Steel
max
Machine Weight (bare tool)
** X may be followed by one or two characters. All models
are the same except model number and trademark.
The suffix in models may be number from "1" to "999"
or English letter "A" to "Z" or "M1" to"M9" which means
different package or the various of accessories packed in
the package.
*** Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage is
18 volts.
NOISE INFORMATION
A weighted sound pressure L
K
= 5 dB(A)
pA
A weighted sound power L
K
= 5 dB(A)
wA
Wear ear protection.
10
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN 62841:
Cutting boards
Cutting wooden
beams
The declared vibration total value and the declared noise
emission value have been measured in accordance with a
standard test method and may be used for comparing one
tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a preliminary
assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ from
the declared value depending on the ways in which the
tool is used especially what kind of workpiece is processed
dependant on the following examples and other variations
on how the tool is used:
How the tool is used and the materials being cut or drilled.
Cordless Reciprocating Saw
300mm
12mm
2.5kg
= 75.0 dB(A)
pA
= 86.0 dB(A)
wA
Vibration emission value
2
a
=5.48 m/s
h,B
Uncertainty K = 1.5 m/s2
Vibration emission value
2
a
= 5.53 m/s
h,WB
Uncertainty K = 1.5 m/s2
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and ensuring
it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off and
when it is running idle but not actually doing the job. This
may significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration and noise exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
Category
Model
WA3014
20V Battery
WA3570
WA3760
WA3772
20V Charger
WA3880
WA3883
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to the
accessory packaging for further details. Store personnel
can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE:
The machine is intended for sawing wood, plastic,
metal and building materials while resting firmly on the
workpiece. It is suitable for straight and curved cuts.
ASSEMBLY AND OPERATION
ACTION
Charging The Battery Pack
Capacity
4.0Ah
5.0Ah
0.4A
2.0A
2.0A
4.0A
FIGURE
See Fig. A1
EN
Werbung
Inhaltsverzeichnis
