Using The Radio; Troubleshooting - ION Pickup Benutzerhandbuch

Using the Radio

Selecting a radio station:
1. Press the Radio button to select AM or FM.
2. Press either of the Tune/Track buttons to select a radio station.
To "seek" (jump to the next available station), hold either button down for a few seconds
until it starts to seek a station.
Note: Pause playback from or disable Bluetooth entirely before using the radio to prevent
both audio signals from being active at the same time.
Saving a radio station as a preset:
1. Press the Radio button to select AM or FM.
2. Press either of the Tune/Track buttons to select a radio station.
3. Press and hold a Preset button to assign the current station to that preset number. The
display will show "SAV" to show the station has been saved.
Recalling a saved radio station preset:
1. Press the Radio button to select AM or FM.
2. Press a Preset button to select a previously saved preset station.
To turn off the radio, press the Radio button until it is set to Off.

Troubleshooting

If the sound is distorted: Try lowering the volume control of your sound source, musical
instrument, or microphone. Also, try to reduce the overall volume of Pickup
Volume knob.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower
the bass level. This will allow you to play the music louder before clipping (distortion) occurs.
If there is a high-pitched whistling noise when using microphones: This is probably
feedback. Point the microphone away from the speaker.
If there is poor AM reception: To adjust AM reception, move entire unit.
If you can't hear the microphone over the music volume: Turn down the music volume
from your source.
If you can't play music from a flash drive: The USB port is only for charging USB devices.
TM
using the Main
7