Cleaning, Care & Maintenance - Buffalo CP821 Bedienungsanleitung

Overload Switch
The Overload switch is situated at the back of the machine. If the appliance becomes too hot the
Overload switch will stop the machine automatically. If this happens:
1. Turn Off the mixer.
2. Reduce the load in the mixing bowl.
3. Push the Overload switch back in to reset it.
4. Allow the appliance to cool for 30 minutes.
Note:
• In the event of a power cut the Overload switch will cut in to prevent the
appliance from restarting automatically when power is restored.
• Always disconnect the Mixer from the mains powers supply when not in use.
Cleaning, Care & Maintenance
• Always turn off the mixer and disconnect from the power supply before cleaning.
• Use warm soapy water to clean the bowl and mixing attachments. Do not use abrasive cleaning
chemicals as these can leave harmful residues.
• Clean the exterior of the appliance with a damp cloth.
• Do not use jet/pressure washers to clean the appliance.
• Clean the appliance regularly.
• Dry all parts thoroughly after cleaning.
Troubleshooting
If your BUFFALO appliance develops a fault, please check the following table before making a call to the
Helpline or your BUFFALO dealer.
Fault
The appliance is The unit is not switched on
not working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
The Stop button not released
The overload switch has activated See overload switch information in the
Safety Guard not closed
The appliance is The mixing bowl is overloaded
overheating
The appliance has been operating
for too long
The appliance is Poor lubrication
noisy
Loose chain
Spiral hook hitting Hook or bowl deformation
bowl
CP821_ML_A5_v3_20211125.indb 7 CP821_ML_A5_v3_20211125.indb 7
Probable Cause
Check the unit is plugged in correctly and
switched on
Call BUFFALO agent or qualified Technician
Replace the fuse
Check mains power supply
Turn Stop button clockwise to release
Operation section of this manual
Close Safety Guard fully
Turn off the appliance and empty some of the
contents
Turn off the appliance and allow to cool down
for 30 minutes
Call BUFFALO agent or qualified Technician
Call BUFFALO agent or qualified Technician
Call BUFFALO agent or qualified Technician
UK
Solution
7
2021/11/25 14:18 2021/11/25 14:18