GBS Jolly line universal Air plus Anleitung Seite 3

1. Remote control preparation
- Slide the rear cover o the battery casing.
- Insert 2 batteries (AAA type) taking care to respect the polarity
indicated.
2. Remote control programming
2.1 Find Brand
- Find the code(s) corresponding to the brand in the code table (e.g.:
if you nd 0188-0196 all codes from 0188 to 0196 are included).
- Insert the code(s) found by direct input
2.1.1 Direct input
- Press the key, the model code on the display ashes.
- Press the 4 keys corresponding to the 4 gures in the code desired.-
Check that the remote functions correctly, if the device does not
respond correctly, insert the next code for that brand (2.1.1)
If the device does not function correctly with any of the codes, e ect
an Automatic search (2.2)
N.B.: Press the key to select the next code
2.2 Automatic search
- Pointing the remote control towards the conditioner, press the
key until the model code starts incrementing (circa 5 sec.)
- Release the key but continue pointing the remote control.
- When the conditioner turns on press any key to stop the search.
- Check that the remote control functions correctly, if the device
does not respond correctly, proceed with the Automatic search (2.2)
3. Clock setting
- Press the key, and the time on the display starts ashing.
- Press the and/or
- Press the key to con rm the time.
4. Programming the Timer ON or Timer OFF function
To work in TIMER mode the remote control must remain oriented
towards the conditioner at a suitable distance
4.1 Timer ON
- Press the key, and the time on the display starts ashing.
- Press the and/or
desired.
- Wait some 5 seconds until the time stops ashing.
INSTRUCTIONS


keys until the correct time is displayed.
keys until you reach the switch on time
UK