Cleaning And Maintenance; Environmental Protection; Gerätebeschreibung - Strend Pro RY-WT8C58-C Gebrauchsanweisung

Detection distance setting:
- The detection distance can be set by turning the knob.
- If you want to reduce the detection distance, turn the knob counterclockwise.
- If you want to increase the detection distance, turn the knob clockwise.
The minimum detection distance is 0.5 m and the maximum 10 m.
Setting the delay time:
- The time delay is activated as soon as the motion sensor detects movement.
- To set the LED lighting time, turn the knob.
OPERATION:
The light works in 3 modes:
I. The motion sensor is activated by sources of infrared radiation which enter the detection range, e.g. people,
animals, etc. After activating the motion sensor, the solar light will light up and will light up if the motion
sensor detects motion in the detection range or until the set time delay has elapsed.
II. The LED light will be constantly lit at low intensity. The motion sensor is activated by sources of infrared
radiation which enter the detection range, e.g. people, animals, etc. After activating the motion sensor, the
solar light will light up and will light up with high intensity as long as the motion sensor detects motion in the
detection range or until the set time delay has elapsed. Subsequently, the solar light will glow at low intensity.
O. The device will not light.
- Do not use abrasive cleaners or organic solvents to clean the surface of the luminaire, as this may damage
it.
- All service work or installation of the luminaire must only be carried out when the luminaire is switched off.
- If the front protective cover of the luminaire is damaged, replace the cover with a new one. For safety
reasons, you cannot use the lamp with a damaged front cover.
- If warranty repair is required, contact the dealer from whom you purchased the product and have it
repaired by an authorized service center. Contact an authorized service center for warranty repair.
Packaging materials are recyclable. Please do not dispose of packaging materials with municipal
waste but dispose of them in secondary material collection centers.
Discarded devices contain valuable recyclable materials that should be re-used. Therefore,
please hand over your old equipment to a suitable waste collection facility. Electrical and
electronic equipment often contains components that may pose a potential hazard to human
health and the environment if handled or disposed of incorrectly. However, these components
are required for proper operation of the device. Instruments marked with this symbol must not
be disposed of with household waste.
ENGLISH
EN
- Die LED-Solarleuchte mit Bewegungssensor ist eine weiße Lichtquelle, die in ihrem Charakter dem
Tageslicht entspricht.

CLEANING AND MAINTENANCE

ENVIRONMENTAL PROTECTION

GERÄTEBESCHREIBUNG