Installation - Chuango RV-500 Bedienungsanleitung

EN

Installation

1. Plug in the charging dock and manually retract any excess charging cable to the
back compartment at the bottom of the dock.
2. Place the charging dock on a hard, level surface, and against the wall, and make
sure the installation place is open and uncluttered leaving at least 2 meters in front
of the dock, 1 meter on both sides of it.
3. Connect the round connector of the adapter into the power socket on the
charging dock and the other end into the wall outlet.
Important: please only use the provided adapter to power the device.
4. Install the side brush: attach a side brush to the bottom of the Robot by pressing
a brush into slot.
5. Turn on the power switch at the bottom.
6. Activate the Robot: place the device onto the charging dock, making sure the
charging contact pins of the charging dock match up with those underneath the
Robot. Once the [ ] button illuminates, the Robot is ready for use.
Please charge the Robot for 5-6 hours before use.
EN